The Sub6 is a large volume cabinet design, equipped with an 11" woofer and a rear laminar port. This configuration guarantees bass linearity whatever the intended SPL. The control board is extremely versatile, with connectivity which allows a 2.1, 2.2 and multichannel use via the L/R inputs and outputs and the LFE. The numerous settings such as the high-pass crossover dedicated to monitors, the adjustable phase and level control provide optimum coupling with the Solo6 Be and the Twin6 Be monitors. And finally, a small, but important point: the footswitch input. It enables one to connect a pedal to deactivate the subwoofer and the high-pass crossovers on the outputs that supply the monitors. This simplifies and greatly improves control during the different stages in monitoring.
Frequency response :
30Hz - 250Hz
Maximum SPL :
116dB SPL (peak @ 1m)
Input :
Right, left, LFE
Electronically balanced, 10 kOhms
XLR 3 points socket
Adjustable
Outputs (towards speakers) :
Type/Impedance: Electronically balanced / 50 Ohms - Connector: XLR 3 points plug
Amplification :
350W rms, BASH® technology
Signal internal treatment :
Subwoofer section: Mono right/left summation
LFE + mono low-pass
24dB/octave
Phase adjustment
Polarity selection switch
Switch high-pass filter, cut-off frequency selection
Speaker section : 24 dB / octave
Electric supply :
Local supply wire: 230V (1.6A fuse)
or 115V (3.5A fuse)
Connection: removable IEC supply wire
Visualization and control :
Adjustable subwoofer level
Low-pass cut-off frequency setting
Phase adjustment
Polarity adjustment
Subwoofer switch (mute)
2.1 "Bypass" (external remote contol)
High-pass frequency selection
Releasable high-pass
warning light :
Power on LED, Subwoofer switch (mute), Released high-pass
Subwoofer :
11W7670, 10-5/8" (27cm) Focal "W" composite sandwich cone driver
Box :
7-1/2" (19mm) MDF panels
Finish :
Dark red natural veneering side panels, black body.
Dimensions (HxWxD) :
14-15/16 x 13-9/16 x 17-5/16 " (380 x 344 x 440mm)
Weight :
50.7lb (23kg)
